The short answer is to slow down, use the right bit, and treat the final tighten as a hand-feel job—not a race. I’ve put together enough balcony chairs and café tables to know that stripping a screw usually happens when the tool is wrong, the torque is too high, or the parts aren’t lined up before you start forcing the hardware.
First, lay everything out and separate the screws by size. Urban outdoor furniture often uses similar-looking screws in different lengths, and mixing them up can make you cross-thread a hole. Check the instructions for the correct screw at each step, and keep a small tray or magnetic dish nearby so you don’t lose washers and bolts.
Next, use the correct driver bit. A bit that’s slightly too small will cam out and chew up the screw head. For Phillips screws, use a fresh bit that seats fully; for hex or Torx, make sure it’s the exact size. If you’re using a drill/driver, set the clutch low—start at 3 or 4 on a typical drill—and let the clutch click before the screw is fully tight. Then finish by hand with a screwdriver. That last quarter-turn by hand is where you can feel resistance and stop before the threads strip.
Clean the threads if the furniture is secondhand or has been outside. Dirt, grit, or light corrosion can make a screw bind. A quick wipe with a dry cloth or a soft brush helps, and a tiny bit of silicone spray or wax on metal threads can reduce friction. Don’t over-lubricate, especially on wood or composite parts, because it can attract grit.
Before tightening, make sure the holes line up. Leave all screws loose for the section you’re building, then snug them gradually in a cross pattern—like tightening wheel bolts. This lets the frame settle instead of pulling one hole out of alignment. If a screw starts to feel tight too early, back it out, check for debris or misalignment, and try again. Never force it.
Support the furniture so it isn’t twisting while you work. A second person helps on larger pieces, but a padded stool or cardboard underneath will do. When using a power tool, keep steady downward pressure so the bit stays engaged. If you feel the bit slipping, stop immediately—continuing is how heads get stripped.
Finally, don’t overtighten. Outdoor furniture expands and contracts with heat and moisture, and hardware needs a little room to move. Snug is enough; if a washer starts digging into the material or the screw stops turning easily, you’re done. A calm, low-torque approach will save you far more time than drilling out a stripped screw later.